19
BACK BURNER LOW HEAT SETTING ADJUSTMENT:
NOTE:
THE LOW HEAT SETTING ON YOUR OVEN IS PRESET AT THE FACTORY. ADJUST ONLY IF ALTI-
TUDE OR ENVIRONMENTAL FACTORS ARE CAUSING POOR, LOW HEAT, PERFORMANCE.
ADJUSTMENT STEPS:
1. Follow lighting instructions and set the control knob on “HIGH” and allow the burner to preheat for 5
minutes.
2. Turn the control knob to “MIN” and wait for the burner temperature to drop and stabilize.
3. Insert a small flat blade screwdriver into the LOW SETTING screw of the gas valve to begin the
flame height adjustment.
4. Turn counter-clockwise to INCREASE the low heat BLUE flame, Clockwise to DECREASE.
5. Adjust the flames so the burner flame is approximately 1/8” to 3/16” in length in the LOW position.
(See
Figure # 12
)
Even if the flame is set very low, the automatic ignition system and its hot surface igniter will continue
glowing as a safety measure, while allowing the safety gas valves to remain open flowing gas to the
burner.
HEARTH STONE (BOTTOM BURNER) LOW HEAT SETTING ADJUSTMENT:
NOTE:
THE LOW HEAT SETTING ON YOUR OVEN IS PRESET AT THE FACTORY. ADJUST ONLY IF ALTI-
TUDE OR ENVIRONMENTAL FACTORS ARE CAUSING POOR, LOW HEAT, PERFORMANCE.
ADJUSTMENT STEPS:
1. Remove the Hearth stone closest to the oven opening in order to view the entire Hearth Burner.
2. Follow lighting instructions and set the control knob on “HIGH” and allow the burner to preheat for 5
minutes.
!
WARNING
NEVER ADJUST THE BURNER SO LOW
THAT IT MAY GO OUT DURING USE. DO
NOT OPERATE THE OVEN WITH THE LOW
HEAT SCREW REMOVED.
GAS CAN ESCAPE AND CAUSE A
POTENTIALLY HAZARDOUS CONDITION.
!
AVERTISSEMENT
NE JAMAIS AJUSTER LE BRÛLEUR SI BAS QU'IL
PEUT S'ÉTEINDRE PENDANT L'UTILISATION.
N'UTILISEZ PAS LE FOUR AVEC LA VIS À
CHALEUR BASSE RETIRÉE.
LE GAZ PEUT S'ÉCHAPPER ET PROVOQUER
UNE
CONDITION
POTENTIELLEMENT
DANGEREUSE.
FLAME SIZE
1/8” ~ 3/16”
MAXIMUM
Figure # 12
BACK BURNER LOW
FLAME SETTING
NON-ADJUSTABLE
AIR MIX
