30
The work surface must be put back into the horizontal position to remove the finished mounting panel.
Release the head screws from the lower pull out section and release the stop bolt on the upper section; turn
until they remain retracted.
The mounting panel can be retracted now.
OPTION FOR EXTENDING THE TABLE
This option allows you to place mounting panels from a length of 1690 mm to 1896 mm horizontally onto
the assembly table, not vertically as before, without having to go without the tried and tested stop bolt for
fixing the mounting panels. This allows you to wire up even very large mounting panels in a comfortable
sitting position. The Table Extension consists of left and right extension sections in the shape of a T, which
respectively fastens into the middle spar of the assembly table and with the head screws supplied in the set.
Figure 12: AMTE250 with extensions
Figure 13: AMTE250 with extensions and mounted panel
The stop bolts can be mounted from above and from below, left and right. The assembly table is now ready
for horizontal fixing of mounting panels.
1. Take a T – section and slide it into the middle
spar from the left. Then take the other T – section
and slide it into the middle spar from the right.
2. The T – sections can be fixed with the supplied
head screws when both T – sections have been
pushed into the middle spar.
