38
GETTING TO KNOW YOUR INSTRUMENT PANEL
Buzzer Volume (Adjusting The Failure/
Warning Buzzer Volume)
With this function, the volume of the buzzer
accompanying any failure/warning indication
can be adjusted to one of eight volume levels.
To adjust the volume, proceed as follows:
1. Briefly push the SET/BACK button. The
previously set volume “level” will flash on
the display.
2. Push and release the up or down arrow
button for setting.
3. Briefly push the SET/BACK button to go
back to the menu screen, or push and hold
the SET/BACK button (approximately one
second) to go back to the main screen
without storing the settings.
Service (Scheduled Servicing) — If
Equipped
With this function, it is possible to
view information on mileage intervals
for servicing.
To obtain this information, proceed as follows:
1. Push the SET/BACK button briefly. The
display shows the service interval in miles
(mi) or kilometers (km) according to the
previous setting (see the “Unit Of
Measurement” paragraph).
2. Briefly push the SET/BACK button to go
back to the menu screen or hold the button
down to go back to the standard screen.
NOTE:
The “Scheduled Servicing Plan” includes
vehicle maintenance at fixed intervals, refer to
“Scheduled Servicing” in “Servicing And Mainte
-
nance” for further information. This message is
displayed automatically along with the warning
light when the key is turned to MAR/ON/RUN -
1,242 miles (2,000 km) before these deadlines
and reappears every 124 miles (200 km).
Below 124 miles (200 km) servicing indications
are more frequent. The indication will appear in
miles or kilometers according to the “Unit Of
Measurement” settings. When the next sched
-
uled service is approaching and the key is
turned to MAR/ON/RUN, the word Service will
appear on the display, followed by the number
of miles or kilometers left. Contact an autho
-
rized dealer. The operations in the “Scheduled
Servicing Plan” will be performed and the
message will be reset.
Daytime Running Lamps
This function may be used to activate/
deactivate the daytime running lamps.
Proceed as follows to switch this function on
or off:
1. Briefly push the SET/BACK button to
display the three submenus.
2. Briefly push the SET/BACK button. “On” or
“Off” will flash on the display (according to
previous setting).
3. Push and release the up or down arrow
button for setting.
4. Briefly push the SET/BACK button to go
back to the menu screen, or push and hold
the button (approximately one second) to go
back to the main screen without storing the
settings.
Exit Menu
This function closes the initial menu screen.
Briefly push the SET/BACK button to go back to
the main screen.
Push and release the up arrow button to return
to the first menu option (Speed Buzzer).
Push and release the down arrow button to
return to the last menu option (Daylights).
V
ALUES
D
ISPLAYED
Indications On Display
Each time a value is selected, the following
information is shown in the instrument cluster
display:
“Trip A” or “Trip B” location(s)
Name, value and unit of measure of the
selected value (e.g. “Range 520 mi”).
20_4C_OM_EN_USC_t.book Page 38
Summary of Contents for 4C Spider 2020
Page 162: ......
