Alfa Romeo 4C Spider 2020, Owner'S Manual

Page: 117 / 164

SERVICING AND MAINTENANCE 115
(Continued)
If the level is not sufficient, namely if there is no
washer solvent inside the pipe, proceed as
follows:
1. To avoid any interference during the
procedure, lift the windshield wiper blade.
2. Loosen the four screws using the supplied
screwdriver. Remove the washer solvent
protection panel.
3. Take the black funnel for topping up the
windshield washer solvent and its extension
pipe from the service kit in the luggage
compartment.
4. Take out the plug with the solvent control
pipe through the washer solvent protection
panel.
5. Introduce the funnel and its extension pipe
in the reservoir neck and top up.
Washer Solvent Fill Funnel
6. After topping up, remove the funnel with the
extension pipe.
7. Refit the plug with the dipstick.
8. Reposition the washer solvent protection
panel and tighten the four self-tapping
screws.
M
AINTENANCE
-F
REE
B
ATTERY
Your vehicle is equipped with a
maintenance-free battery. You will never have
to add water, nor is periodic maintenance
required.
WARNING!
Commercially available windshield washer
solvents are flammable. They could ignite and
burn you. Care must be exercised when filling
or working around the washer solution.
WARNING!

Battery fluid is a corrosive acid solution and
can burn or even blind you. Do not allow
battery fluid to contact your eyes, skin, or
clothing. Do not lean over a battery when
attaching clamps. If acid splashes in eyes
or on skin, flush the area immediately with
large amounts of water. Refer to “Jump
Starting Procedure” in “In Case Of Emer -
gency” for further information.

Battery gas is flammable and explosive.
Keep flame or sparks away from the
battery. Do not use a booster battery or any
other booster source with an output greater
than 12 Volts. Do not allow cable clamps to
touch each other.

Battery posts, terminals, and related acces -
sories contain lead and lead compounds.
Wash hands after handling.

The battery in this vehicle has a vent hose
that should not be disconnected and
should only be replaced with a battery of
the same type (vented).
CAUTION!

It is essential when replacing the cables on
the battery that the positive cable is
attached to the positive post and the nega -
tive cable is attached to the negative post.
Battery posts are marked positive (+) and
negative (-) and are identified on the battery
case. Cable clamps should be tight on the
terminal posts and free of corrosion.

If a “fast charger” is used while the battery
is in the vehicle, disconnect both vehicle
battery cables before connecting the
charger to the battery. Do not use a “fast
charger” to provide starting voltage.
WARNING! (Continued)
7
20_4C_OM_EN_USC_t.book Page 115