Error displays (built-in CD player only).
•
Mechanical error.
– Press
. After the error indication disappears,
insert the disc again. If the above-mentioned
solution does not solve the problem, consult your
nearest authorized dealer.
CD-R/CD-RW playback not possible.
•
Close session (finalization) has not been performed.
– Perform finalization and attempt playback again.
MP3/WMA
MP3 or WMA is not played back.
•
Writing error occurred. The MP3/WMA format is not
compatible.
– Make sure the MP3/WMA has been written in a
supported format. Refer to “About MP3/WMA” on
page 32, then rewrite in the format supported by
this device.
Audio
The sound is not output from the speakers.
•
There is no signal output from the internal amplifier.
– Power IC is switched to “ON”.
iPod
iPod does not play and no sound is output.
•
The iPod has not been recognized.
– Reset this unit and the iPod. Refer to “Initial System
Start-Up” on page 18. To reset the iPod, refer to the
Owner’s Manual of the iPod.
CD Player Messages
No Disc
•
No CD is inserted.
– Insert a CD.
•
Although a disc is inserted, “No Disc” is displayed
and the unit does not start to play or eject the disc.
– Remove the disc by following these steps:
Press the
button again for at least two seconds.
If the disc still does not eject, consult an authorized dealer.
Error
•
Mechanism error.
1. Press the
button and eject the CD.
If not ejecting, consult an authorized dealer.
136
ADDITIONAL INFORMATION
