21/24
ALFA IN a.s. ©
www.alfain.eu
CAUTION
4. Do not blow air into the welder during cleaning. Blowing air into the welder
can cause metal particles to interfere with sensitive electronic components
and cause damage to the welder.
5. To clean the welder, disconnect it from the mains supply voltage then open
the enclosure and use a vacuum cleaner to remove any accumulated dirt
and dust. The welder should also be wiped clean. If necessary, solvents
that are recommended for cleaning electrical apparatus may be used.
6. Troubleshooting and repairing of the aXe welding equipment should only
be carried out only by suitably qualified or competent person.
7. A ‘competent person’ must be a person who has acquired through training,
qualification or experience, or a combination of them, the knowledge and
skills enabling that person to safely carry out a risk assessment and repairs
to the electrical equipment in question.
8. The person carrying out the servicing needs and repairs must know what
to look at, what to look for and what to do.
OPERATIONAL SAFETY INSPECTION OF THE MACHINE ACCORDING TO
ČSN EN 60 974-4
Prescribed operations of tests, procedures, and required documentation are
listed in ČSN EN 60974-4. SERVIS
ERROR MESSAGES
The left display
V10
shows Err, the right display
V11
shows number of the error.
Err 1
Overheating of the machine. DO NOT POWER OFF THE MACHINE!
TROUBLE SHOOTING
Symptom
Reason
Solution
The torch is too
hot
Nozzle is not fixed.
Tighten the nozzle
Button on the
torch does not
respond
Connectivity of EURO
connector is loose
Tighten EURO connector
Damaged wiring in the
torch
Check and replace if
necessary.
Irregular wire feed
or wire is caked to
the nozzle.
The wire on the spool is
too tightly wound.
Check and replace the
spool if necessary.
The ball is fused to the
nozzle.
Cut out the ball and piece
of the wire at the
beginning.
Irregular or no
wire feed.
Poor pressure in the
wire feed rolls
Adjust the pressure
according to this
instruction manual.