- 27 -
ALFA IN a.s. ©
www.alfain.eu
Fig. 17 – Synergy advice
9.
ROUTINE MAINTENANCE & INSPECTION
•
The only routine maintenance required for the ALF range of machines is a
thorough cleaning and inspection, with the frequency depending on the
usage and the operating environment.
WARNING
•
Disconnect the ALF from the mains supply voltage before disassembling.
•
Special maintenance is not necessary for the control unit parts in the
Welder. If these parts are damaged for any reason, replacement is
recommended.
CAUTION
•
Do not blow air into the welder during cleaning. Blowing air into the welder
can cause metal particles to interfere with sensitive electronic
components and cause damage to the welder.
•
To clean the welder, disconnect it from the mains supply voltage then
open the enclosure and use a vacuum cleaner to remove any
accumulated dirt and dust. The welder should also be wiped clean. If
necessary, solvents that are recommended for cleaning electrical
apparatus may be used.
•
Troubleshooting and repairing of ALF welding equipment should only be
carried out only by suitably qualified or competent person.
•
A ‘competent person’ must be a person who has acquired through
training, qualification or experience, or a combination of them, the
knowledge and skills enabling that person to safely carry out a risk
assessment and repairs to the electrical equipment in question.
