5
3 INSTALL
3.1 BABY UNIT: (CAMERA)
The baby parent unit is not waterproof and therefore only suitable for
indoor use.
Power adapter:
1. Connect one of the supplied power adapters with de connector xx on the back
of the baby unit.
2. Insert the adapter into a 230V outlet.
Only use the supplied power adapter with modelnumber TGE050P055.
Make sure the baby can not touch the baby unit or the cord. Place the baby unit
at least 2 meters away from the baby and bundle long wires with tape or with
purpose-available wire ties.
Tabletop or wall model:
You can use the baby unit loose on a table, closet or office setting or hang on the
wall.
For wall mounting:
Drill next to each other and with a mutual distance of 3.3 cm, two holes in the wall
and insert plug and screw. Let the head of the screw protruding a few millimeters.
Hang the baby unit by sliding the notches into the camera standard on the screws
in the wall and by pushing the baby unit slightly downwards. Finish finally the
adapter cord neatly with cable brackets.
Placing advice:
• In case of use as a babymonitor place the baby unit on a minimum distance of
2 meters away from your baby and make sure the adapter
• cable is safely tucked away.
• For an optimal range, it is preferred to set up the baby unit as high as possible,
free from large metal surfaces.
3.2 PARENT UNIT:
The parent unit is not waterproof and therefore only suitable for indoor use.
Power:
The parent unit can be powered directly from the supplied rechargeable battery or
the included power adapter. Once you connect the power adapter, the battery is
charging, so the parent unit can be used mobile.
Battery:
1. Open the battery compartment by sliding the battery cover off the back of the
parent unit.
2. Place the battery.
