PLASMA CUTTER
9
1300 777 137
AUS
AFTER SALES SUPPORT
PLASMA 35 60485 04/2018
parts in the vicinity. Avoid direct contact with the welding
circuit. The no load voltage between the earth clamp and the
torch can be dangerous under certain circumstances.
5.9 FOR ADDITIONAL PROTECTION FROM ELECTRIC SHOCK
It is recommended that this tool be used in conjunction with
a residual current device (RCD) with a rated residual current
of 30mA or less.
5.10 CONSIDER WORK AREA ENVIRONMENT
Do not expose the plasma cutter to rain. Do not use it in
damp, or wet locations. Keep the work area well lit.
5.11 DRESS PROPERLY
Use protective gloves and fire resistant protective clothing
and footwear when using the cutter. Avoid exposing skin to
the ultraviolet rays produced by the arc.
5.12 ALWAYS USE THE WELDING MASK
Under no circumstances should the cutter be operated unless
the welding mask is protecting the eyes and face. There is a
serious risk of eye damage if the mask is not used. The sparks
and metal projectiles can cause serious damage to the eyes
and face.
The light radiation produced by the arc can cause damage to
eyesight and burns on the skin. Never remove the welding
mask whilst cutting. Move the torch away from the work
piece and release the trigger switch before removing the
welding mask.
GENERAL SAFETY WARNINGS
