PLASMA CUTTER
18
1300 777 137
AUS
AFTER SALES SUPPORT
PLASMA 35 60485 04/2018
NOTE:
If the duty cycle of the machine is exceeded the thermostatic protection
will activate.
WARNING!
When you have finished cutting, switch off the plasma cutter. Do
not put the torch down with the plasma cutter switched on. When
leaving the plasma cutter unattended, move the On/Off switch to the
Off position and disconnect it from the mains supply. Do not leave hot
material unattended after cutting.
NOTE:
Water may drain from the water drain (11) after use. This is moisture
from the air supply. The amount of water depends on many factors such as
temperature and humidity.
8. CLEANING MAINTENANCE AND STORAGE
8.1 CLEANING
WARNING!
Any maintenance operation including cleaning,
changing/checking consumables etc. SHALL be carried out with the
plasma cutter switched off, disconnected from the mains supply and
the air supply disconnected. Allow the plasma cutter to cool before
performing maintenance or cleaning.
• After use wipe the plasma cutter, torch assembly and cables down with a
soft dry cloth.
8.2 MAINTENANCE
8.2.1 PLASMA CUTTER
• There are no user serviceable parts inside the welder. Refer to qualified
service personnel if any internal maintenance is required.
CLEANING, MAINTENANCE AND STORAGE
