March 2005
CLI Basics
31
Inserting Characters
To insert a character between characters that are already typed,
use the
Left
and
Right
Arrow
keys to place the cursor into
position, then type the new character. Once the syntax is
correct, execute the command by pressing
Enter
. In the
following example, the user enters the wrong syntax to execute
a command. The result is an error message.
-> show micrcode
^
ERROR: Invalid entry: "micrcode"
To correct the syntax without retyping the entire command
line, use the
!!
command to recall the previous syntax. Then,
use the
Left
Arrow
key to position the cursor between the “r”
and the “c” characters. To insert the missing character for this
example, type “o” as shown:
-> !!
-> show microcode
Previous Command Recall
To recall the last command executed by the switch, press the
Up Arrow
key at the prompt and the previous command will
display on your screen. You can execute the command again
by pressing
Enter
or you can edit it first by deleting or insert-
ing characters.
Prefix Recognition
Prefix recognition is a CLI feature that reduces redundant
command line entry by storing commonly-used prefix infor-
mation for certain commands. The CLI assumes this stored
prefix information when the next command is entered. For
example, if you enter
-> vlan 32
at the command line, the CLI will store the
vlan 32
prefix
information.
The following command families support prefix recognition:
•
AAA
•
Interface
•
Link Aggregation
•
Quality of Service (QoS)
•
Spanning Tree
•
VLAN Management
