14
Installing the Hardware
March 2005
2
The module should slide in easily. Do not force the
module into the slot. If any resistance is encountered,
ensure the module is aligned properly in the card guide.
Also, see the important note regarding chassis card guides
on
page 13
.
3
When the module is nearly seated in the slot, be sure
that the two extractor levers—one on top of the module
and one on the bottom—are slightly opened (approxi-
mately 30 degrees). This allows the notch on each extrac-
tor lever to grasp the rail on the chassis. Once the notches
have grasped the rail, press both extractor levers simulta-
neously until the module is firmly seated.
4
Once the module is firmly seated, secure the module to
the chassis by tightening the two captive screws
. Be sure
not to overtighten the captive screws. If you use a screw-
driver, the torque used to tighten the screws must not
exceed 2.3 inch pounds.
5
Install all remaining modules by repeating steps 1
through 4 for each module.
OS7
-ENI
-C24
OK1
OK2
4x
1
2
3
NI
Notch in Extractor
Lever
Chassis Attachment
Rail
OS7-ENI-C24
1x
3x
5x
OK1
OK2
8x
6x
4x
OS7-ENI-C24
1x
3x
OK1
OK2
6
4x
1
2
NI
