Installation Guide: 601, 602, and 604 Routers
29
4
C
ONFIGURATION
This chapter describes how to login; change the default password, configure the router and
users, and change the factory default configuration. The boot process and software upgrade
process is also discussed in detail.
Logging In
If you have not established a local console connection, see Operator Interface on page 27 for
more information.
The following figure shows the login sequence and the initial prompt after login is complete.
Figure 23 Initial CLI Prompt
NOTE:
The default host name is Alcatel.
Command Tips
Use the following command tips and shortcuts with command line interface commands.
To display all commands, type
tree
.
To access help associated with a command, type
help
<
command name
>. You may also use
the
?
key after any command.
To exit back one level in the command hierarchy, type
exit
and press Return.
To exit the command mode and/or return to the base CLI prompt, press the key
combination
Ctrl-Z
.
Type the first two letters of a command, and then press the
Tab
key to automatically spell
out the command.
Scroll through the available commands using the
Tab
key.
Ethernet Configuration Tip
To avoid Ethernet mismatch problems, the OmniAccess 601, OmniAccess 602, and OmniAccess
604 router and the network device to which it is attached should both be configured
identically for speed and duplex. For example, if the router is configured for auto-negotiation
Initial CLI Prompt
login: username
password:
username logged in on Fri August 6 05:28:01 2004
from console
Alcatel CLI
Alcatel-model>
