23
Installation Guide: 601, 602, and 604 Routers
Figure 16 Wall Mounting the OmniAccess 602 and OmniAccess 604 Router
1
Attach the router to the wall mount assembly using four (provided) Phillips pan head 4-40
x .250 inch screws.
Ensure that the router is oriented in a manner that allows the LEDs to be visible.
2
Attach the assembly with the mounted router to the wall surface with four (provided) 6 x
1 inch (for OmniAccess 602 and OmniAccess 604) or 4 x 1 (for OmniAccess 601) Phillips pan
head screws and hollow wall plastic anchors.
NOTE:
The provided hollow wall anchors are not designed for installation in hard walls. These anchors
should only be installed in a sheet rock (gypsum wall board) wall.
3
Fit the AC strap over the power supply and then place the power supply on the wall mount
bracket within the four locating tabs.
4
Engage and tighten the AC strap captive screw to secure the power supply to the wall
mount assembly.
5
Attach the cable retainer to the DC power cord behind the molded strain relief on the
cable.
6
Insert the DC power cable jack into the 12 VDC port on the back of the router.
7
Engage and tighten the captive screw on the cable retainer in the threaded hole adjacent
to the DC input jack on the router.
8
Connect the appropriate ends of the AC cord to the secured power supply and a 110/120
VAC outlet.
