Alcatel-Lucent Enterprise OmniSwitch 6865, Hardware User'S Manual

Page: 32 / 63

OmniSwitch 6865 Hardware Users Guide 28
Installing Power Supplies for Rear Mount Trays
1. Orient the power supply as shown below. Insert the guide pins (located on either side of the DB-15
connector) into the guide holes in the rear of the chassis.
For this example, table mount assembly shown.
2. Push the power supply into place until the connector is fully seated and tighten the thumb screw at
the front of the power supply unit.
3. For redundant power supply configurations, repeat these steps using the power supply connector
and thumb screw hole located at the other side of the chassis and power supply tray.
Note. The switch does not provide an on/off switch. Instead, the switch powers
on when a power cord is plugged into the power supply’s front panel and
plugged into a power source.
Hole for Guide Pin