4.2 AUTOMATIC MODE
4.2.1
CASH:
when
a note or coin is inserted, the credited amount is displayed, and the control board starts the
pay-out by the hopper(s). The pay-out will contain coins from both the hoppers. If the CPU is set to
Change, all the tokens that can be bought by the inserted sum will be dispensed, and change will be
returned if any. At the end of the payout cycle, the display will show both the inserted amount as well as the
amount paid out.
4.2.1.A PAY-OUT TABLE ENABLED AND PROGRAMMED:
when a note or coin is inserted, the display
shows the credited amount, and the hopper shall automatically pay-out according to the combination that the
Operator has pre-programmed for the amount inserted (see section 5.2.4.3
DISPENSING MODE SETUP
). By
enabling such pay-out table from the menu settings, the User will only be able to get the tokens and/or coins
that can be bought by the inserted money, according to the combination preset by the Operator. See the setting
flow-chart in section 5.2.4.3
.
4.2.2
POS:
POS payments shall only allow to obtain tokens. If the CPU is set for dispensing coins, POS operation
will be automatically disabled. POS will be available only if the hoppers in the system are single-coin; in systems
including multi-coin Hoppers (Discriminators) the configuration menu shall make the POS option unavailable.
Operation takes place as described in section 4.1.2 POS above, with the provision that the User will be able to
choose only among the payment levels preset by the Operator.
Please notice: if, within 30 seconds after having pressed the SEL- button, the User has not
continued the payment steps, the system returns to stand-by.
WARNING: If there are not enough coins/tokens in the hopper to fulfil the whole payout request, the remaining
credit shall be displayed and retained in memory. Pawer off the system, fill the hoppers, and switch on again:
the remaining credit shall be paid out.
An alternative option is to set the Remaining Credit Menu (see section 7.3.14) so as to cancel the remaining
credit - and at the same time record it in the Accounts menu - by switching the system off and on again.
4.3 RECHARGE OF CARD / KEY
When equipped with the ACS Card/Key reader (see 7.3.5D), the Money Changer can operate as recharger of
credit for User Card/Keys. These can then be used to purchase services or goods from nearby self-service
dispensers or distributor kiosks, provided that the ACS readers in such kiosks have been initialized with the
same PIN as the one programmed in the CPU. When the User Card/Key is in the Hira ACS reader, and money
is introduced, the display will prompt for pressing any green-lit button to load the credit onto the Card/Key.
4.4 OPERATIONS WITH RFID CARD/KEYS
If the system is equipped with the ACS Reader for the RFID Card/Keys, it is possible to use such Card/Keys to
obtain or perform useful functions, according to which type of Card/Key is inserted.
4.4.1 Operation with User Card/Key
When inserting a compatible RFID User Card/Key (must be
initialized with the same password as the RFID reader - see
section
7.3.5D
SET UP CASHLESS
), the available credit gets
shown, and a pushbutton will lit up and flash green.
If more credit must be loaded, insert coins and/or notes
until the desired value is attained, then wait until the
storing message (“Data are being stored”) disappears,
then remove the Card/Key now loaded with new credit.
The Card/Key can now be used to buy services/products
from systems equipped with ACS reader provided that such
ACS readers too have been initialized with the same password as the RFID reader in the system.
Press green button
to load credit
Available Credit:
NN,nn