7.
CMS ARM PCB as replacement for CMS Freescale PCB
The new CMS and CCS ARM CPU p.c. boards have different connectors with respect to the old CMS and CCS.
As a consequence, when replacing an old CMS / CCS pcb by a new ARM one, it is necessary to order the Hub
“C
oncentrator
” in
terface AA-0177 and the relevant adapter cables S-030153-000 and S-030174-000.
Remove the existing Power-in cable (green MOLEX connector) from the existing pcb. Connect each of its wires -colour to
colour- through the Molex connector to the loose wires of the S-030153-000 cable. Then connect the opposite end of the
latter cable to any suitable socket on the interface Hub pcb.
Connect the S-030174-000 cable to the P10 socket in the new ARM pcb.
Remove all cables from the existing pcb, and connect them onto any suitable socket on the interface Hub pcb.
Connect the pushbutton cables to sockets P5, P6, and P8 of the new ARM pcb, according to the below diagram.
P10 = from Concentrator Hub pcb: POWER and CCTALK DATA
4 pin [1=+24V, 2=+12V, 3=GND, 4=CCT DATA]
P5 = to RGB
“
OK
”
PUSHBUTTON
2x3 pin [ Pin 1 = MICROSWITCH N.O., Pin 2 = RED LED,
P6 = to RGB
“
SEL-
” PUS
HBUTTON (3-pushbutton machines only)
Pin 3 = +12V, Pin 4 = BLUE LED, Pin 5 = GND,
P8 = to RGB
“
LANGUAGE / SEL+
” PUS
HBUTTON (*)
Pin 6 = GREEN LED ]
P3 (TTL1) = to the VPOS Terminal (only CCS ARM p.c. boards)
4 pin [Pin 1=GND, Pin 2=RX, Pin 3=TX, Pin 4=+12V]
P9 = for optional external programming keypad
5 pin (available for K-P3N-000006 keypad)
(*) To use the POS in 1-hopper machines equipped with only 2 pushbuttons, it is necessary to connect this
LANGUAGE/SEL+ pushbutton to P6. The amount to be paid will be determined by pressing the revolving SEL- button.
As a consequence, the courtesy LANGUAGE function will no longer be available.
Cable
S-030174-000
(12-24-GND-ccTalk)
To Coin Acceptor
To Note Validator
To Hopper(s)
Cable S-030153-000 (*)
from Power Box
(12-24-GND)
P7 P4 P8 P6 P5
P10
P11
P13
P3
(TTL1
)
P2
(TTL2
)
P9
P12
1
1
1
1
Hub pcb
“Concentrator”
AA-0177
