Albatron PX925X Series, User Manual

Page: 35 / 64

PX925X/PX925XE Series
31
Resources Controlled By
BIOS can automatically configure all the boot and Plug and Play compatible devices. If
you choose Auto, you will not be able to manually assign IRQ DMA and memory base
address fields, since BIOS automatically assigns them. Options: Auto (ESCD) (default)
、
Manual
IRQ Resources
When resources are controlled manually, you can assign each system interrupt a type,
depending on the type of device using the interrupt. This is only configurable when
“Resources Controlled By” is set to “Manual”.
Options: IRQ-3/ 4/ 5/ 7/ 9/ 10/ 11/ 12/ 14/ 15 assigned to PCI device
PCI / VGA Palette Snoop
Some graphic controllers that are not VGA compatible take the output from a VGA
controller and map it to their display as a way to provide boot information and VGA
compatibility.
Options: Disabled (default)
、
Enabled
PCI Latency Timer (CLK)
This item allows you to set up the PCI Latency Time (0-255). If you select the “32” it will
optimize PCI speeds. Options: 0-255
、
32 (default)
PCI SLOT1-3
This item allows you to select an IRQ address for PCI slot 1-3.
Options: Auto (default)
、
3
、
4
、
5
、
7
、
9
、
10
、
11
、
12
、
14
、
15
**PCI Express relative items**
Maximum payload Size
This item allows you to set the PCI Express Maximum payload size per time. Options: 4096
(default)
、
128
、
256
、
512
、
1024
、
2048
Frequency/Voltage Control
Afterburner Mode
This item allows you to enable or disable afterburner mode function. If you set to
“enabled”, the system will automatically over-clocking for the current state and keep the
system normalize when the power load over the regular value range. Until the power
restore the regular value range, the system will also restore the default clock range. The
regular value range is depending on the peripheral devices you installed. Please set to
“disabled” when the system is always in over-clocking state or it is always in
nonover-clocking state. Options: Disabled (default)
、
Enabeld
CPU Host Frequency (MHz)
This item displays the CPU Host frequency. You can set it from XXX to 300. The default
depends on your CPU frequency. The default for this field depends on the CPU installed.