Albatron PI965GME-M, User Manual

Page: 16 / 34

Mainboard PI965GME-M
12
Reset Switch Header: RST_SW
This header can be attached to a momentary SPST switch (reset button) cable on your case front
panel. The switch is normally left open. When the switch closed, it will cause the mainboard to reset
and run the POST (Power-On Self Test).
Speaker Header: SPK1
A speaker cable on your case front panel can be attached to this header. When you reboot the
computer, this speaker will issue a short audible (beep). If there are problems during the Power On
Self-Test, the system will issue an irregular pattern of audible beeps through this speaker.
Connectors
Hard Disk Drive Connector: IDE1
The mainboard provides one IDE connector that supports Ultra ATA 133/ 100/ 66/ 33 IDE devices. You
can attach a maximum of two IDE devices, such as hard disk drive (HDD), CD-ROM, DVD-ROM, etc.
using IDE ribbon cables.
In general, two IDE devices can be attached onto one IDE connector. If you attach two IDE HDDs, you
must configure one drive as the master and the other one as the slave.
Serial ATA Connector: SATA 1/2/3
The three SATA connectors support 3 Gbps data transfer rates, and one SATA connector only can
attach one SATA HDD of each time using SATA cables.
LVDS Connector: LVDS
This mainboard supports one 24-bit LVDS (Low Voltage Differential Signaling) connector. You can
attach one flat panel display or other compatible display device.
Pin Assignment Pin Assignment
1 PC_BEEP 2 N/A
SPK1
3 Ground 4 +5V