14
Instructions for re-activating the PE2 input
1.
Press and hold the
Reset/Menu
button
for 3-5 seconds.
2.
The display will read
LIMIT SETUP
. Press the
UP ARROW
button until the
display reads
MODULE CONFIGURATION
. Press the
ENTER
button.
3.
Press the
UP ARROW
button until the display reads
MOD B…
Press the
ENTER
button two times.
4.
The display will read
Photo 1 (Front)
.
5.
Press the
UP ARROW
button
until
Not Assigned I2
is displayed. Press
ENTER
.
6.
Press the
UO ARROW
button until the display reads
Photo 2 (REAR) Press
ENTER
.
7.
The lower left hand corner The cursor will be flashing under
NO.
Press the
UP
ARROW
button
and
change to
NC
, press
ENTER .
8.
Press the
RESET
button two times to get back to the main menu. Push the
RESET
button again to get the door ready to run. The display will read
DOOR READY
and the cycle count. The door is now ready to run.
Summary of Contents for R-BAC UltraSmart
Page 1: ...UltraSmart ...
Page 18: ...18 ...
