Albalá Ingenieros SEM2000C01, Manual

Page: 18 / 26

Albalá Ingenieros | Manual SEM2000C01
The following functions of the SEM2000C01 can be performed remotely:
- Configuration of the datarate and the operating mode for the ports.
- Supervision of the status of the links that are established in each port.
- Supervision of the status of the 10MHz reference.
4.3.1. Details of the SEM2000C01 registers
The SEM2000C01 module provides control and status registers that can be read and
written by means of specific commands described in the communication control
module user manuals.
The parameter information grouped in the CONTROL or RAM sections is stored in
volatile memory. Any modifications to the parameters will be lost when the module
power supply is disconnected unless the "EEPROM Save" button within the software
has been pressed.
The STATUS section parameters are read-only and cannot be modified.
The EEPROM section parameters are rarely used and are stored directly in non-volatile
memory.
The parameters that can be controlled and supervised remotely for each version of
the firmware are listed below:
VERSION 1.X
CONTROL
Name add ext msk snmp trap Description
MSK_SFP_PRES 0x00 0x01 N N SFP present mask
0=Disabled, 1=Enabled
MSK_SFP_FAULT 0x00 0x02 N N SFP laser fault mask
0=Disabled, 1=Enabled
MSK_SFP_LOS 0x00 0x04 N N SFP loss of signal mask
0=Disabled, 1=Enabled
MSK_P1_ETH 0x00 0x08 N N Port 1 link down mask
0=Disabled, 1=Enabled
MSK_P2_ETH 0x00 0x10 N N Port 2 link down mask
0=Disabled, 1=Enabled
MSK_PO_ETH 0x00 0x20 N N Optical Port link down mask
0=Disabled, 1=Enabled
MSK_BUS_UNLOCK 0x00 0x40 N N 10 MHz lock fail mask
0=Disabled, 1=Enabled
MSK_BUS_LOS 0x00 0x80 N N 10 MHz loss of signal mask
0=Disabled, 1=Enabled
P1_ETH_MODE 0x02 0x07 Y N Ethernet mode in Port 1
7=Auto, 0=10Mbps HD, 4=10Mbps FD, 1=100Mbps HD, 5=100Mbps FD,
2=1Gbps HD, 6=1Gbps FD
P2_ETH_MODE 0x03 0x07 Y N Ethernet mode in Port 2
7=Auto, 0=10Mbps HD, 4=10Mbps FD, 1=100Mbps HD, 5=100Mbps FD,
2=1Gbps HD, 6=1Gbps FD
PO_ETH_MODE 0x04 0x01 Y N Ethernet mode in Optical port
1=2.5Gbps, 0=1Gbps
0=No, 1=Yes
STATUS
18