Albalá Ingenieros SEM2000C01, Manual

Page: 13 / 26

Albalá Ingenieros | Manual SEM2000C01
module to disable the module's retention mechanism and release it. Finally, pull module
carefully out of its receptacle.
There are different types of SFP/SFP+ modules. Make sure that module to be installed is
appropriate for the receptacle that will contain it.
3.5. Installing the module in the mounting frame
The following steps should be followed in order to install a SEM2000C01 module in the
mounting frame.
1 - Remove the blank panel covering the front of the empty slot chosen for installing the
SEM2000C01 in the mounting frame.
2 - Insert the SEM2000C01 module into the front of the mounting frame. The edges of
the card slide into two plastic guides inside the mounting frame.
3 - Secure the module to the mounting frame using the two front screws.
After these steps, the module is ready to be connected to other equipment.
3.6. Interconnection
The arrangement of the front panel connectors of the SEM2000C01 module is shown in
the following figure.
Front panel of the SEM2000C01
The two RJ-45 connectors labeled PORT 1 and PORT 2 are electrical interfaces for
13