Albalá Ingenieros FRS3004C02, Manual

Page: 22 / 32

Albalá Ingenieros | Manual FRS3004C02
The following functions of the FRS3004C02 can be performed remotely:
- Selection of the reference input.
- Adjustment of the levels of the output signals.
- Supervision of the status of the reference input an the inputs to be synchronized.
4.4.1. Details of the FRS3004C02 registers
The FRS3004C02 module provides control and status registers that can be read and
written by means of specific commands described in the communication control
module user manuals.
The parameter information grouped in the CONTROL or RAM sections is stored in
volatile memory. Any modifications to the parameters will be lost when the module
power supply is disconnected unless the "EEPROM Save" button within the software
has been pressed.
The STATUS section parameters are read-only and cannot be modified.
The parameters that can be controlled and supervised remotely for each version of
the firmware are listed below:
VERSION 1.X
CONTROL
Name add ext msk snmp trap Description
REF_SOURCE 0x00 0x01 Y N Allows selecting the reference signal
0=Analog, 1=Digital
FAIL_MODE 0x00 0x02 Y N Allows selecting the output video signal if the input fails
0=Freeze, 1=Black
SYNCHRO_MODE 0x00 0x04 Y N Allows selecting the synchronizing mode
0=Frame, 1=Line
VBI_MODE 0x00 0x08 Y N Allows selecting if the VBI is blanked
0=Pass, 1=Blank
NO_REF_MASK 0x01 0x01 N N Allows masking no reference signal fail
0=Disabled, 1=Enabled
REF_UNLOCK_MASK 0x01 0x02 N N Allows masking reference input unlock fail
0=Disabled, 1=Enabled
REF_EDH_ERR_MASK 0x01 0x04 N N Allows masking reference input subcarrier unlock fail
0=Disabled, 1=Enabled
EDH_ERROR_MASK 0x01 0x08 N N Allows masking the EDH errors
0=Disabled, 1=Enabled
NO_SIG_1_MASK 0x01 0x10 N N Allows masking no SDI signal fail (Section 1)
0=Disabled, 1=Enabled
NO_SIG_2_MASK 0x01 0x20 N N Allows masking no SDI signal fail (Section 2)
0=Disabled, 1=Enabled
NO_SIG_3_MASK 0x01 0x40 N N Allows masking no SDI signal fail (Section 3)
0=Disabled, 1=Enabled
NO_SIG_4_MASK 0x01 0x80 N N Allows masking no SDI signal fail (Section 4)
0=Disabled, 1=Enabled
H_DELAY_1 0x02 0x07FF Y N Allows adjusting the video horizontal delay (Section 1)
= 37.037*x ns
V_DELAY_1 0x04 0x03FF Y N Allows adjusting the video vertical delay (Section 1)
= x lines
LUMA_GAIN_1 0x06 0xFF Y N Allows adjusting the luma gain (Section 1)
= x/128
22