12
Quick Start
First Time Start Up
1. Unpack the lock.
2. With the batteries disconnected, hold down the
;
key for 10 seconds and release.
3. Connect the batteries and listen for 3 beeps.
4. Wait 15 seconds, and listen for 6 additional beeps (LED will flash twice). The lock is ready to program when it
unlocks.
Important Note:
When entering any key sequence below,
do not pause more than 25 seconds between
any key presses
--otherwise you must start again.
Enter Program Mode and Change Factory Master Code
1. Press the default Master Code:
1
2
3
4
5
6
.
If the lock should fail to unlock using this Master Code, proceed directly to
ERASE ALL PROGRAMMING--
RESTORE FACTORY DEFAULT
on the previous page and then perform this
Quick Start
procedure again.
2. Wait for the green light and press
;
until multiple beeps are heard. You are now in Program Mode.
Note:
The lock will beep every 6 seconds as a reminder that you are in Program Mode.
3. Enter a new personal 6-digit Master Code number by pressing the following keys:
;
1
;
[
new Master Code
]
;
[
new Master Code
]
:
(the second set of digits must be exactly the same).
(For example, if you want your new Master Code to be “664433”. Press:
;
1
;
664433
;
664433
:
).
Now that the Master Code has been changed, there is no need to change it again (unless you want to). Since you
are still in Program Mode, you can now proceed directly below and program various functions.
Note:
Program-
ming any Function, such as setting the clock, follows a consistent 5-step pattern: (1) Enter Program Mode (2)
Press
;
[Function #] (3) Press
;
and enter data (4) Press
:
to end (5) Exit Program Mode.
Note:
There is a 3 minute Program Mode timeout if no keys are pressed when in Program Mode. A steady tone
will sound for the final 15 seconds of the 3 minute timeout period as a warning. To remain in Program Mode, press
any key.
Set the Weekday
1. Enter Program Mode (if not in already).
2. Press
;
40
;
[
number of weekday
]
:
. (Use 1= Sunday, 7 = Saturday).
(For example - Friday - press
;
40
;
6
:
).
Set the Date
1. Enter Program Mode (if not in already).
2. Press
;
38
;
[
MMDDYY
]
:
.
(For example - May 10, 2006 - press
;
38
;
051006
:
).
Set the Time
1. Enter Program Mode (if not in already. If you just finished the above procedure, you are still in Program Mode).
2. Press
;
39
;
[
HHMM
]
:
. (Use 24-hour military format, where PM adds 12 hours).
(For example - 2:30pm - press
;
39
;
1430
:
).
Enter User Codes
1. Enter Program Mode (if not in already).
2. Press
;
2
;
[
User Number
]
;
[
new User Code
]
:
.
(For example, John Smith is designated as User 21. You want him to use the code of “232323” to unlock the door.
Program the lock by pressing:
;
2
;
21
;
232323
:
).
3. Repeat step 2 for each new user.
