Alamo Schulte SRW 1400, Operator'S Manual

Page: 77 / 83

MAINTENANCE
Maintenance Section 5-7
© 2004
Alamo Group Inc.
MAINTENANCE
SRW1400 10/04
Grease Schedule
Grease should meet the following recommendations:
-SAE Multi-purpose grease
-SAE Multi-purpose grease containing 3 to 5 per cent molybdenum disulfide
Use SAE (NLGI) #2
IMPORTANT: Before attaching the driveline, clean and grease the tractor
PTO and the Implement shaft.
Universal Joint Assemblies.
-Cross Journal: Every 8 hours.
Apply only one or two strokes from a hand-type grease gun. Over lubrication may cause damage
to seals.
-Shield Retaining Bearing: Every 8 hours.
-Inner Sleeve: Every 20 hours. Pull the universal joint halves apart and apply grease to all sides
of the slip shaft.
-Push Pin: Every 20 hours.
-Telescoping Tubes: Every 4 hours. Apply grease to the collar located at the middle of the shaft.
Occasionally (monthly) pull the universal joint halves apart and apply grease to all sides of the slip
shaft. At least once per year (more often in dusty or dirty conditions) the shielding should be
removed and the old grease removed with a solvent. A fresh coat of grease should then be applied
to the entire surface of the inner tube.
IMPORTANT: If the universal joint sliding members are allowed to dry out to the point where two
halves cannot slip freely, damage to the rock windrower or tractor may occur.
Windrower Frame
-Drum Frame Clamps: 8hrs
-Interlock Rotator: 8 hrs
-Transport Wheel: 50 hrs
-Pivoting Wheel Assembly: 50 hrs, 8 Locations
-External Flange Bearings: 50 hrs 3 locations. All flange bearings are permanently lubricated, however grease
fittings are provided on the external units. Grease should be pumped into the bearing until it is seen purging at
the clearance between the outer race and slinger.
Wheel Hubs
-Wheel Hubs: Yearly. Fill until grease is seen purging at the axle seals.