Installation
akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany · Tel.: +49 (0) 511 16 59 672-0 · www.akytec.de
21
5. Installation
The safety requirements from the section 1.5 must be observed.
5.1 Mounting
The device is designed to be installed on DIN rail or using two screws on a mounting panel in an electric
cabinet.
The operating conditions from the Sect. 3.2 must be considered when choosing the installation site.
Dimensional drawings are given in Appendix A. Only the vertical positioning of the device is allowed.
Fig. 5.1 DIN rail mounting
Device replacement (Fig. 5.2):
−
switch off the power supply of the module and all connect-
ed devices
−
open the front cover 1
−
loosen the two screws 3
−
remove the terminal block 2
Now you can replace the device.
Reverse this procedure after replacing the device.
Fig. 5.2 Device replacement
5.2 Wiring
WARNING
The device must be powered off before connecting to other equipment or PC. Switch on
the power supply only after the wiring of the device has been completed.
NOTICE
Ensure that the input signal is connected to the correct input terminals and that the input
configuration corresponds to the signal. Non-observance can cause the device damage.
NOTE
To ensure compliance with the EMC requirements:
−
Signal cables should be routed separately or screened from the supply cables.
−
Shielded cable should be used for the signal lines.
