Aktobis WDH-930EEW, Operating Manual

Page: 3 / 16

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: info@aktobis.de
Please switch off the unit immediately and disconnect it from the mains/power supply if anything
seems to be wrong !!! In this case, please contact a specialist and do not attempt to repair the
unit yourself !!!
Examples: Fan does not run during operation, fuse has blown or compressor rattles loudly.
Important operating and safety instructions regarding the refrigerant R290 in this unit:
(Read these instructions carefully and observe them before using the unit !)

The refrigerant R290 complies with the European environmental directives !

The unit operates with the refrigerant R290. This refrigerant is highly flammable and
explosive if the safety instructions are not observed!

The unit contains 0.125 kg of refrigerant R290 - the maximum permitted charge of refrigerant
R290 for dehumidifiers is 0.3 kg !

The minimum air circulation is 160 m³/h !

The appliance must be stored in a room without continuously operating ignition sources (e.g.
open flames, an operating gas appliance or an operating electric heater).

Protect the unit and especially the parts installed inside from damage or flames/heat !

Please note that the refrigerant is odourless and therefore a leak cannot be detected
immediately by an emerging odour !

If refrigerant leaks, it may ignite or explode, especially in poorly ventilated rooms in
conjunction with high heat, sparks or flames !

Make sure that the outlet of the exhaust air is always ensured and not obstructed by other
objects !

Set-up, operation and storage of the unit should take place in a room with a minimum size of
4
m2 !

Pack the unit carefully when you are no longer using it to protect it from damage ! Be careful
when storing the unit to avoid mechanical faults.

When cleaning, proceed strictly according to the manufacturer's instructions and do not use
any additional heat sources to possibly accelerate the defrosting process of the appliance!

Never work on the cooling circuit or parts containing refrigerant yourself !

Only persons authorised and certified by an accredited agency to handle refrigerants should
work on the refrigerant circuit.

If the mains lead of this appliance is damaged, it must be replaced by the manufacturer or its
after-sales service or a similarly qualified person in order to avoid hazards.

The unit must be installed according to the national installation regulations.

Do not use any objects, except those permitted by the manufacturer, to accelerate the
defrosting process.

Do not drill or burn.