Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
Email: [email protected]
4. Other operating instructions
4.1. Do not disconnect the mains plug by pulling on the power cable !
4.2. Do not use insect repellent, oil spray, paint spray, etc. in the vicinity of the building
dryer. This may cause damage to the unit or even fire !
4.3. Do not place the appliance on sloping or uneven ground !
4.4. Please always keep a distance of approx. 20 cm to the wall to avoid possible
overheating of the appliance. Furthermore, please also ensure a distance of approx.
50 cm upwards when drying laundry !
4.5. For an effective and economical dehumidification operation, please close all doors and
windows in the room of the building dryer !
4.6. Please keep the unit away from heat sources !
4.7. Always hold and transport the unit in its proper and upright position !
4.8. Do not insert any objects into the appliance. This is dangerous !
5. Cleaning
5.1 Cleaning the housing
a. Please disconnect the mains plug before cleaning the construction dryer.
b. Only use mild cleaning agents to clean your construction dryer.
c. NEVER spray your building dryer (e.g. with water or similar).
5.2 Cleaning the air filter
The air filter filters lint, hair and coarse dust, ensuring that this dirt is not blown
back into the room air. Furthermore, the air filter ensures that less dust is
deposited on the cooling fins, thus ensuring higher efficiency. The air filter is
coated with an antibacterial glaze, which inhibits the proliferation of bacteria and
germs.
Clean the filter whenever it can be assumed that the air intake is reduced by
the dirty air filter !
Reach into the notch at the top of the air filter and then pull it carefully (see
illustration on the right), this will allow the air filter to be removed from the
construction dryer.
It is best to clean the air filter carefully under lukewarm water or with a low-
setting (suction power) hoover.
Put the cleaned air filter back in its holder in reverse order - DONE.
