22 |
P a g e
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT PRIOR NOTICE. SHOULD YOU HAVE ANY QUESTION, PLEASE FEEL FREE TO CONTACT OUR SALES
REV 1.0.2
Akribis Systems Pte Ltd
Blk 5012 Techplace II #01-05 Ang Mo Kio Avenue 5
Singapore 569876
Tel: +65 6484 3357 Fax: +65 6484 3361
RCB Reg No: 200410879N GST Reg No: 20-0410879-N
3.
Configure the setting accordingly:
Setting
Value Allowed
Remarks
Number of Bit for BiSS C Interface, n
12-bit to 32-bit
For 27-bit to 32-bit, the data will be
automatically truncated into 26-bit from
MSB of original data width as MR-J4
driver only supports 26-bit
Duplex Type
Half duplex
–
2 wire
Or
Full duplex
–
4 wire
NIL
Mitsubishi Alarm Mask
Check the specific number of checkbox
available to mask the corresponding
Mitsubishi Alarm Number
NIL
4.
After finished configuring the setting, click
“
Write Setting to Flash
”
to write the setting configured into the flash of
ITF-21-BISS-MIT
5.
To confirm the setting is
successfully written, click “Read Setting from Flash”
and inspect the value
6.
In order to let the configured setting take effect, power cycle (power off and on the adapter) is required.
7.
After power cycle, the effective setting should be checked thru information page of PC software and NOT thru
configuration page. [IMPORTANT]
8.
“Load Setting” allows user to load file from a previous saved setting which is in “
.pickle
” format.
9.
“Save Setting” allows user to save a configuration setting
for future reference and use.
