AKO AKO-16520, User Manual

Page: 20 / 32

1652H302 Ed.03
20
Alerts
The device alerts the user through an on-screen message when an event occurs which requires his/her attention.
However, it does not activate the sound alarm or the alarm relay (if active).
Defrost finished by time alarm
The message Adt is displayed when a defrost has completed due to time-out, if parameter A8 =1.
Pump down malfunction error (stop)
The message Pd is displayed if a malfunction is detected when the installation is stopped using the
pump down manoeuvre. (See p. 11).
Pump down malfunction error (start-up)
Displays the LP message if a malfunction is detected when the installation is started up using the
pump down manoeuvre. (See p. 11).
Light control
Relay AUX 1 or AUX 2 must be configured as “Light” ( o00 or o10 =2).
Switching the lights on or off is controlled using:
The
push-button: One press switches the lights on or off.
The cold room door: When the door is opened, the lights remain on for the time defined by parameter b01 . If the
value is 0, when the door closes the lights go out. (One of the digital inputs must be configured as door contact
(
I10 or I20 =1).
The control even occurs with the equipment in Stand-by.
Password
It allows protecting the configuration of the unit using a 2 digit code (from 01 to 99). If it is
active a code is requested when you try to access the programming menu. This menu cannot
be accessed if a wrong value is entered. The code is set via the
PAS parameter.
Parameter b10 defines the operation of this code.