AKO AKO-16520, User Manual

Page: 3 / 32

3
Versions and references
MODEL DESCRIPTION POWER SUPPLY
CIRCUIT BREAKER
PROTECTION
CONTACTOR
AKO-16523
4 relay temperature
controller
230 V~ ± 10%, 50 Hz ± 5%
No
No
AKO-16520
120 V ~ + 8% - 12%, 50 Hz ± 5%
AKO-16523P
5 relay temperature
controller
230 V~ ± 10%, 50 Hz ± 5%
Yes
AKO-16520P
120 V ~ + 8% - 12%, 50 Hz ± 5%
AKO-16523D 230 V~ ± 10%, 50 Hz ± 5% No Yes
AKO-58500 CAMM Module
- - -
AKO-16523P / AKO-16520P AKO-16523 / AKO-16520
AKO-16523D
AKO-58500
CORE CORE CORE CORE
Warnings
-If the equipment is used without adhering to the manufacturer's instructions, the device safety
requirements could be compromised. Only probes supplied by AKO must be used for the unit to operate
correctly.
2
-From -40 ºC to +20 °C, if the NTC probe is extended to 1000 m with at least a 0.5 mm cable, the maximum
deviation will be 0.25 ºC (cable for probe extension ref. AKO-15586 . Earth the cable mesh at one end only).
-Only NTC type probes supplied by AKO must be used for the appliance to operate correctly.
-It must be installed in a place protected from vibrations, water and corrosive gases, where the ambient
temperature does not exceed the value indicated in the technical data.
-For the reading to be correct, the probe must be used in a place without thermal influences apart from the
temperature you want to measure or control.
-IP65 protection degree is only valid with the protection cover closed.
-The IP65 protection degree is only valid if the cables enter the device through a tube for electric co
gland with IP65 or above. The size of the glands must be suitable for the diameter of the tube used.
-Do not spray the unit directly with high-pressure hoses, as this could damage it.
Maintenance
Clean the surface of the unit with a soft cloth, water and soap.
Do not use abrasive detergents, petrol, alcohol or solvents, as this might damage the unit.
1652H302 Ed.03