AJS Highway Star 125, Owner'S Manual, Page: 46 / 61

42
CHANGE THE HEAD LIGHT BULB
1) Allow the lamps to cool before touching them.
2) Unscrew the small screws at the bottom of the
head light rim as shown at point
3) Pull the front rim off of the head light shell.
4) Unclip the head light bulb and replace, ensuring that
the locating tabs are located correctly. NB: be careful
not to touch the glass of the halogen bulb with your
fingers. Grease from your fingers will cause an early
failure of the bulb. Use gloves.
ABOUT THE HEAD LIGHT BULB
The headlight bulb is a double filament bulb. One
filament provides the high bean whilst the other
provides the low beam. The filaments are located at
different positions from the reflector so as to produce
two different beam levels (one high and one low)
If either the high or low beam fails, you should replace
the bulb.
In order to avoid contamination of the bulb glass
surface, do not touch with your bare fingers.
Grease from your fingers will cause the brightness
of the bulb and the life of the bulb to be reduced. If
you inadvertently touch the bulb, wipe it clean with
denatured alcohol such as methylated spirits.
NOTICE!
Rim retaining screw
1
1