AJP PR5 250, Owner'S Manual, Page: 32 / 38

AJP PR5
User’s manual – 3 rd
Edition
– Rev 1
Page
28
Replace a blown fuse only with an
equivalent one. If a new fuse that has
just been set in gets blown again, you
are strongly advised to have it
inspected by an AJP dealer.
! CAUTION !
Under no circumstances is a
stronger fuse allowed to be set in
or a fuse to be “repaired”. An
inexpert treatment could damage
the whole electrical installation.
LIGHT BULB REPLACEMENT
Replacing headlight lamp
Loosen both rubber bands (1) and tilt
headlight mask to the front.
Remove rubber protection, lose
retaining clip and remove gently lamp
holder out of headlight glass.
Press lamp inside, rotate it counter
clockwise and remove it away from
holder.
When placing a new lamp, do not touch
the glass body of the lamp so it remains
free from fat. Engage retaining clip and
mount rubber cap and connector.
Reinsert parking light lamp together
with holder and fix the mask by means
of the rubber bands.
Use only 12V25/35W BA20d lamps.
Replacing parking lamp
Remove lamp holder out of glass, press
and rotate counter clockwise to remove
lamp.
Install a new lamp on the bush and
place it on the mirror of headlight glass.
Taillight
Note: rear light is a set of LEDs and
does not allow for replacing, because
they are unchangeable. In the event of
a presence or stop light failure, it is
necessary to replace all the rear spoiler
assembly.
AIR FILTER
Cleaning air-filter
A dirty air filter restricts airflow rate,
reduces the engine performance and
increases fuel consumption, therefore
clean it in regular intervals.
For this purpose, remove drivers seat,
by unscrewing to screw (1) inside the
rear fender and pull it in to rear
direction. Then remove ai
r filter’s cover
by unscrewing fixation screw (2).
1