Mounting the Base Station Radio (BSR)
31
3.
Attach the U-bolt to the pole:
a.
Place one U-bolt around the pole, and then insert the U-bolt screw side through the
two corresponding holes (horizontally parallel) on the clamping bracket. Slide an M8-
flat washer and M8-spring lock washer onto each U-bolt screw side (ensure that the flat
washer is adjacent to the clamping bracket). Fasten each U-bolt side with the two M8-
hex nuts.
b.
Attach the second U-bolt as described above.
4.
Perform final MicroMAX orientation:
a.
Adjust the vertical position of the MicroMAX by choosing a final elevation hole as
described in Step 2. Lock the MicroMAX at the desired position by inserting the locking
bolt in the desired position and fastening it tightly. Fasten tightly the bolt in the pivot
hole. The figure below illustrates the angles (in degrees) of each elevation hole. As
Summary of Contents for 605-0000-742
