Page
3
of
5
- You may start unrolling the Slide. Roll out in the correct direction and unfold it. Please
locate and take out all the anchor ropes, making sure all the upper anchors are properly
tied with a rope. You won’t be able to reach them after the unit is inflated.
- If you must connect the 2 parts: there are 4 points to start folding the Dutch Lacing system.
See the Dutch Lacing Starting and Ending Points above. You can identify these points by
the loose ropes (on the Structure) and the Splitting on the flap with eyelets (on the Slide).
Insert the first knot in the first hole, then start folding, connecting them as show below.
- Start the folding from point 1 to point 2 and finish it by tying the loose rope to the cam
buckle. Next step is similar: folding from point 2 to point 3 and finish it by tying it to the
cam buckle. Then follow the same steps from point 3 to point 4, and point 4 to point 1. (for
the lacing Starting and Ending points see fig. 1).
IT IS IMPERATIVE TO USE ALL THE
CAMBUCKLES AT EVERY ENDING POINT
of the lacing system, because in the case
one fails, the other 3 will still be able to hold the Slide on the Structure.
- From the Splitting, you must start folding
either to right, either to left. This is how it
looks when you START to connect the
Dutch lacing.
- At the end of folding, you
MUST
insert the loose rope(s) in the remaining loop(s), and make
sure to connect those rope(s) to the cam buckle system shown below. This way making it
impossible for the lacing system to untie itself.
LOOSE ROPES
SPLIT