Airo X RT Series, Use And Maintenance Manual

Page: 57 / 118

Use and Maintenance Manual - X_RT Series Page 57
7.3 General maintenance
Below are listed the main maintenance jobs to be done and the relevant schedule (the machine features an hour meter).
Operation Frequency
Screw tightening (see paragraph "Various adjustments") After the first 10 working hours
Oil level check in hydraulic tank After the first 10 working hours
Check of the battery state (charge and liquid level) Every day
Coolant level check in the radiator (models “RTD”) Every day
Check of deformation of tubes and cables Every week
Check of stickers and code plates Every month
Articulated joints and sliding blocks greasing Every month
Oil level check in hydraulic tank Every month
Check of heat engine fixing on elastic supports Every month
Emergency devices efficiency check Every year
Electric connections check Every year
Hydraulic connections check Every year
Periodic operation check and structure visual check Every year
Screw tightening (see paragraph "Various adjustments") Every year
Pressure relief valve calibration check Every year
Lifting circuit pressure relief valve calibration check Every year
Brake system operation check Every year
Air purging from oscillating axe cylinders Every year
Inclinometer operation check Every year
Platform overload controller operation check and adjustment Every year
M1 microswitch operation check Every year
Operation check of Microswitch M1S (if available) Every year
Operation check of Microswitches ST1A÷ST4A and STP1÷STP4 (machines with levelling
outriggers) Every year
Operation check of Microswitch M13 on oscillating axle Every year
Dead-man switch check efficiency Every year
Platform extraction clearance adjustment Every year
Hydraulic filter replacement Every two years
Total oil change in hydraulic tank Every two years
DIESEL (D) AND ELECTRIC-DIESEL (ED) MODELS. As it is possible to install different types of Diesel
engines, refer to the instructions manual of the engine manufacturer for all maintenance operations.
IT IS NECESSARY
TO SEND THE MACHINE TO THE MANUFACTURER FOR A COMPLETE CHECK
WITHIN 10 YEARS OF WORK