Airo A16 J Series, User Manual

Page: 44 / 128

User’s Manual – A16 J A18 J Series Page 44
5.1.3.6. Warning lights
Fig. 7
5.1.3.6.1 Green pilot lamp (ZA), operator's station enabled.
The pilot is ON with flashing light when the machine is switched on. If you enabled the control panel on the basket, and
this pilot flashes it means that the controls are not active because the dead-man pedal has not been pressed, or it was
pressed for over 10 seconds without performing any operation.
The pilot is ON with steady light while the machine is running and the dead-man pedal has been pressed for less than 10
seconds. If the control panel in the basket is enabled, all controls are activated (unless triggering of other alarms – see
next paragraphs).
5.1.3.6.2 Red pilot lamp (ZB): warns when the battery is out of charge. (only available on
electrical models)
This pilot starts flashing when battery is charged at 20% only flashing when the battery charge is down to 20% (only
models "E" or "ED" with DC electric pump). In this condition lifting operations and extension of the telescopic boom are
disabled. In this case, recharge the batteries immediately.
5.1.3.6.3 Red pilot light (ZC): diesel engine fault or low fuel
This pilot indicates a malfunction of diesel engine or low fuel.
It lights up with steady light when the machine is on; the platform controls are activated; and Diesel power is selected.
Diesel Engine off ready for start-up. Insufficient engine oil pressure.
Slow flashing when: the engine head is overheated. If on, it stops the diesel engine; if off, it prevents the diesel engine
from starting.
Quickly flashing when the fuel is running low (only approx. 10 l fuel left in the tank). This warning is active only when the
engine is running.
Very fast flashing when the fuse on the electric fan of the air/oil exchanger (if present) is burnt out. CAUTION! Change
the fuse. Danger of overheating of hydraulic oil.