FAQ
Q1. How to reset the device?
When the router is powered on, pushing the “Reset” button with a needle. The LEDs
starts to flash and hold for 10 more seconds. Then release it and the Router will
reboot. Wait for about 2 minutes, then the factory default reset is completed.
Q2. If pairing a new Sub Router fails (Mesh LED flashes for 2 minutes before
stopping), what should I do?
Place the new Sub Router near the Main Router. press the WPS button respectively
again and wait patiently.
Q3. Why wired Mesh networking fails?
Please check the connection between a LAN port of the Main Router and a LAN port
of the Sub Router via a network cable.
Q4. If I want to switch the Mesh connection back to wireless after successful wired
networking, what should I do?
Disconnect the wired connection between the Sub Router and the Main Router,
power off and restart the Sub Router. When the Wi-Fi LED is ON, press the MESH
buttons of the Sub Router and Main Router to pair. Pairing is successful when both
the MESH LEDs of the Main Router and Sub Router are ON.
Q5. Mobile phones and other devices can connect to the router but cannot access
the Internet. What should I do?
01. Check whether the WAN LED is normal. The WAN port of the Main Router must
be connected to your Broadband Gateway (i.e., DSL/Cable modem, PON gateway)
with a network cable.
02.Check whether the Internet LED is normal. Make sure the broadband service is
normal and please contract service provider to check.
03.When all above are normal, try reboot the Router check the network once it
powers on.
Summary of Contents for W6184QAX
Page 1: ...User Manual Wi Fi 6 AX 1800 Indoor Gigabit Router W6184QAX ...
Page 40: ......