STEP 19 - OPENER ADJUSTMENTS continued........
19-5: Press the open button and then stop the door approximately 12” below the desired opening height.
19-6: Loosen the set screw on the Open Limit Cam (Innermost Green Cam) and rotate it clockwise until
the limit switch is pressed in from below. Retighten the set screw. (FIG. 19B)
19-7: Now press the close button and stop the door when it is approximately 12” above the floor.
19-8: Loosen the set screw on the Close Limit Cam (Inner White Cam) and rotate it counterclockwise until
the limit switch is pressed in from above. Retighten the set screw. (FIG. 19C)
19-9: Depending on the speed you have chosen for the opener, you may have to fine tune adjust the limit
cams. This is due to the coasting nature of the opener.
Run the door open and closed and adjust the fine tuning screw on the Open/Close limit cams until the
door stops at the desired open and close positions.
Limit Switch
Fig. 19B
Limit Switch
Fig. 19C
**IMPORTANT**
Once the opener limits have been set, any adjustment to the opener speed will
require that you adjust the opener limits as well.
STEP 20 - MOTOR COVER INSTALL
20-1: Thread a 3/8” nut on the two outer mounting bolts located on the motor side bearing plate.
(FIG. 20A)
20-2: Remove the front panel of the motor cover.
20-3: Lift the motor cover up and around the motor and align the slots in the mounting bracket with the
mounting bolts that you threaded a nut onto. Push the motor cover onto the bolts until it is snug
against the wall. (FIG. 20B)
Summary of Contents for XRS Elite
Page 1: ......
