STEP 12 - MOUNT BOTTOM SUPPORT BAR
12-1: Install the outer, bottom support bar to each bearing plate using (2) 5/16” x 1” bolts. (FIG. 12A)
FIG. 12A
STEP 13 - INSTALL COVER BOLTS
13-1: Lay the double wide support bar flat on the ground with the black rubber seal on top.
13-2: Slide (5) 1/4”X1/2” hex head bolts into the slot next to the rubber seal as shown below. (FIG. 13A)
13-3: Space the bolts evenly along the length of the support bar.
FIG. 13A
STEP 14 - MOUNT DOUBLE SUPPORT BAR
14-1: Flip the double support bar over so the rubber seal is on the bottom.
14-2: Mount the double support bar to the slot in the bottom of each bearing plate using (4) 5/16” x 1” bolts.
14-2: Do not tighten these bolts yet. Leave them loose so the bar can slide in the slot.
5/16” x 1” bolts
(Do not tighten yet)
Black rubber seal
on bottom
Summary of Contents for XRS Elite
Page 1: ......
