WWW.AIRLESSCO.COM TEL: 805-523-0211 FAX: 805-523-1063
Email: [email protected]
WWW.AIRLESSCO.COM TEL: 805-523-0211 FAX: 805-523-1063
Email: [email protected]
PART NUMBER 176-040
For suction fed injection of sand into the water stream for abrasive cleaning. (High pressure spray tip not included.)
SPECIFICATIONS
Maximum Pressure
3500 PSI (241 bar)
Maximum Temperature 200 F (93 C)
Weight
13 lbs. (5.9 kg)
Material
Plated Carbon Steel,
Aluminum, Carbide,
Rubber.
I
OPERATION
1.
Place the sand induction probe in the sand supply container.
2.
Connect and open the water supply line before starting the unit.
3.
Trigger the gun to relieve air in the equipment.
4.
Start the unit.
5.
Trigger the gun to activate the spray.
Always test spray on scrap material first! High pressure spray can damage the surface if the sandblaster is held too close.
6
.
Check the distance you will need to hold the spray nozzle from the surface by starting to spray at the scrap of material
from a distance of several feet. Gradually move closer, checking frequently to see if the high pressure spray is
damaging the surface.
7.
See Application below for the type of sand recommended for your work surface.
NOTES:
Always point the sand nozzle downward when not spraying. This will prevent water from entering the sand supply.
If water does get into the sand supply hose, remove the probe from the sand, hold gun trigger open, and let the hose air dry.
Always be sure sand hose is dry before using.
• Keep the sand covered to prevent the over spray from wetting the sand.
• Do not allow small fragments of sand bags to fall into sand supply. Small paper fragments could prevent sand flow.
SHUTDOWN
After sandblasting operation is complete, remove the probe from the sand, trigger the gun to clear the hose and probe of sand.
Remove the hose from the mixing head and rinse with water to remove all the sand, before storage. Before using the gun for
other applications be sure to reinstall the tip guard, nozzle and male quick coupler.
SANDBLAST KIT - OPTIONAL ITEM
PARTS LIST
ITEM PART #
DESCRIPTION
QTY.
1
103202
Nozzle, Sand
1
2
700005
Gasket
1
3
103201
Housing, Mixing Head 1
4
202003
Thumbscrew
1
5
530010
Adapter, Tip
1
6
176-006
Coupler, Male,
1
Quick Disconnect
7
680001
Hosebarb
1
8
176-018
Hose Clamp
2
9
176-016
Hose, Sand
1
10
176-017
Probe, Sand
1
*P.N. 10200001 Sandblasting kit complete
** Gun, Wand not included.
(A 15 spray angle spray tip of the appropriate orifice size for your
equipment must be used for proper operation.)
31
