6
Installing the Display and Cables
Routing the Sensor Extension Cable
1. Starting from where you mounted the bracket, route the drive
axle extension cable along the axle and the frame, and then
through the cab irewall to where you will install the in-cab
display on the dash. If possible, route along an existing wire
harness. Be careful to avoid routing along pieces of the
frame that may move or cause wiring to rub.
2. The drive axle sensor extension cable will be connected to
Sensor Port A on the back of the QuickLoad display once the
display is installed.
3. Coil and secure the drive axle extension cable approximately
every foot along the frame of the truck using zip ties. Leave
the ties loosely attached, as you will tighten them later in the
install process.
Note: Keep all cables a minimum of 12” from exhaust piping or
properly shield cables.
Drive Axle Connections
Summary of Contents for QuickLoad
Page 17: ...15 Notes ...
