2
Tools Required
The list below contains the tools (customer supplied) to properly
install the delection sensor on the Mack Camelback Suspension.
•
Sander/grinder
•
40-grit medium sandpaper
•
Chalk or permanent marker
•
22mm combination wrench
•
Torque wrench, 20 – 120 ft-lb
•
22mm socket and 3/8-inch socket handle
•
Enamel spray paint
•
Tape measure
•
C clamps
•
ARC or MIG welder
•
5/16 socket or lathead screwdriver
Note: Heavy calibration must be done using maximum vehicle
loads. See QuickLoad Calibrations and Operations manual, for
additional information on calibration.
Cables to the sensor, and any other Air-Weigh wiring, must be
separated by a minimum of 12 inches, or properly shielded, from
exhaust piping.
Do not move vehicle until the alignment tool is removed.
Do not calibrate sensor following installation until the vehicle has
been in operation for one week or 800 miles, whichever comes
irst. This serves as a break-in period.
Summary of Contents for QuickLoad
Page 17: ...15 Notes ...
