12
If the A/D reading is below 750, or there is no A/D reading at all,
follow the steps below:
1. Loosen the nuts on both ends of the sensor
2. At the plastic nut where the cable enters the sensor, exert
UPWARD
pressure with your ingers until the A/D reading
is between 750 and 1250. Continue to apply pressure
to maintain the desired A/D reading during the torque
procedures in step 3.
3. Tighten the nut on the cable end of the sensor and torqued
to 60 ft/lbs.
Continue to apply pressure with your inger
to the plastic nut during torquing in order to maintain
the desired A/D reading
.
If the A/D readings are still
within the 750 to 1250 range after the nuts on both sides
of the sensor have been torqued to 60 ft/lbs., continue to
instructions for the
Final Sensor Torque
.
Final Sensor Torque
1. Torque both nuts to
120 ft/lbs
.
2.
Perform a inal check to A/D values using the readings from
the in-cab QuickLoad display, not from the A/D Box. If A/D
readings are not within range, repeat the
Adjusting the
A/D reading steps.
Summary of Contents for QuickLoad
Page 17: ...15 Notes ...
