4
Welding the Deflection Sensor Brackets
1. Assemble the jig installation kit (alignment tool), as shown
above. Make sure the bracket halves are pushed flush
against the spacer pins in the center of the jig and the space
between the brackets is equal and consistent before and
after tightening the bolts.
2. Hold the bracket/jig assembly to the underside of the arm
over the location you chose for installation earlier. The bottom
of the J shaped bracket should face inboard towards the cab
to optimize the protection of the arm sensor. Use C-clamps to
hold the bracket/jig in place.
3. Using a permanent marker, mark the circumference of the
bracket holes on the arm.
4. Remove the C-clamp and bracket. Remove the paint on the
arm to bare metal where indicated by the marker. Make sure
there is no paint remaining where the bracket will be welded.
5. Replace the bracket over the sanded area and secure them
in place with the C-clamps.
Assembling the Bracket and Alignment Tool Jig (# 111-0025)
Summary of Contents for BinMaxx
Page 25: ...22 Notes...
