16
A/D Box (P/N 1001)
Adjusting the A/D Reading
If the A/D reading is above 1250, follow these instructions
1. Loosen the nuts on both ends of the sensor.
2. At the plastic nut where the cable enters the sensor, exert
UPWARD
pressure with your finger until the A/D reading is
between 750 and 1250, (1000 is an ideal reading). Continue to
apply pressure to maintain the desired A/D reading during the
torque procedures.
3. Tighten the nut on the NON-CABLE side to 60 ft/lbs first,
while maintaining the A/D output at a reading between 750
and 1250 by exerting the proper pressure with your finger
on the molded nut at the cable end of the sensor; repeat this
process for the nut on the cable side of the sensor.
If the A/D
readings are still within the 750 to 1250 range after the nuts
on both sides of the sensor have been torqued to 60 ft./lbs.,
continue to instructions for the
Final Sensor Torque
.
If the A/D reading is below 750, follow the steps below
1. Loosen the nuts on both ends of the sensor.
2. At the plastic nut where the cable enters the sensor, exert
DOWNWARD
pressure with your finger until the A/D reading
is between 750 and 1250 (1000 is an ideal reading). Continue
to apply pressure to maintain the desired A/D reading during
the torque procedures.
Summary of Contents for BinMaxx
Page 25: ...22 Notes...
