Installation Step 4
- Attach Metal Spout:
REMOVE THE PLASTIC
Innner Cover
Screw the flexible Metal Spout clockwise into the outlet connector on top of
the water ionizer.
Installation Step 5
-
Connect the Inlet Water Hose to the Faucet
Diverter Valve:
Connect the Inlet Water Hose to the top faucet diverter valve
and the Acidic Water Outlet Hose into the bottom valve.
Inlet Water Hose
On Top
Acidic Water Outlet Tube
On the Bottom
17
Owner’s Manual: AirWaterLife.com Aqua-Ionizer Deluxe 9.0
Installation Step 5a
(special) Connect the Inlet and Acid Water Hoses to the
Faucet Diverter Valve:
There are two (2) barbed post hose connectors for the hoses on the Faucet
Diverter Valve. The 'top' barbed post connector is for outgoing water which when
diverted with the control handle will flow into the water “in” port on the bottom right
side of the unit (control panel facing you). This is called your 'supply line'.
The 'bottom' connector is for the 'acidic' 'out-line' from the left bottom of the unit
(control panel facing you) this ‘out-line’ allows the acidic water to flow out of the
small spigot next to the larger spigot (normal water flow is from the larger spigot).
This diverter when attached to the faucet end provides alkaline water when the
diverter is activated or normal tap water if the diverter is set for tap water.
In order to attach either hose to the top or bottom connector the
hose must be
'slid' onto the Diverter about 1/2 inch. You can also use a few drops of water
inside the hose to help “slide” the hose onto the barb connector.
For More Help Call 888-601-5886
CAUTION: Be sure that the Metal Spout, and the white ¼” hoses for the source
water ('IN') and the acidic ('OUT') are attached correctly to the bottom of the unit as
described in Steps 3 & 4.
