Page 19
Air Techniques, Inc.
Classic, Ortho & Intraoral
Configure the Intraoral Plate Guides.
If the desired Plate Guides are not in place, install the guides
for the plate size to be scanned . Do not operate the scanner without a full complement of four guides
in place . Any combination of Guides may be used . See Figure 10 .
Figure 10 . ScanX Plate Guide Installation
Activate Scanner.
Activate ScanX by performing the following procedures .
1 . Make sure the computer and ScanX are correctly connected as shown in Figure 2 .
2 . Switch the scanner from STANDBY to the READY mode by pressing the POWER switch .
3 . Verify that the POWER and ERASER Status LED Indicators illuminate bright blue .
4 . Activate the Scanner and select the desired image type and resolution via the imaging software .
5 . Verify that the four Numeric Lane Indicators with Visual Pointer LED Indicators illuminate bright
green as shown by Figure 11 when the Scanner has been activated, indicating that the imaging
software is set to acquire images and PSPs can be fed into the corresponding lane Plate Guides .
Figure 11 . Front Panel Indicators of Activated ScanX Set in the READY Mode
INTRAORAL IMAGING PROCEDURE
Scanner
Lane #3
Plate Guide
Numeric Lane
LED Indicators
(green / amber)
Visual Pointer
LED Indicators
(blue / amber)
POWER
Switch / Status
LED
Indicator Illuminated
Blue
ERASER
Switch / Status
LED
Indicator Illuminated
Blue
