Page 13
Air Techniques, Inc.
Classic, Ortho & Intraoral
SYSTEM SETUP
Figure 2 . ScanX Power and Computer Connections
Exit Side Plate Supports Installation (ScanX Classic & ScanX Ortho only)
The supports are used to catch extraoral plates after processing . Refer to Details C and D below and
install the supports as follows .
CAUTION:
ScanX weighs up to 51 pounds. Two people may be required to perform this
installation to prevent damage to the unit.
1 . Carefully tilt the ScanX back enabling access to the slots under of the ScanX .
2 . Align the two quick connect clips of each support with the corresponding slots .
3 . Insert each support into the slots until a click is heard .
4 . Return the ScanX to the upright position on the installation site counter top .
Detail B
Type B USB
Connector
Type A USB
Connector to
Computer
TO
POWER
SUPPLY
Power
Supply
Note: The power line cord is the
Mains disconnect device.
Line Cord
Type B USB
Receptacle
Inlet Power
Jack
ScanX
Side
Quick
Connect Clips
Slots
Detail C
ScanX
Underside
ScanX
Power and Computer
Receptacles Located on Right Rear Panel
Power Supply
Line
Cord
Detail A
Align Clips
& Slots
Detail D
Snap
Supports in
Place
To ScanX
Inlet
Power
Jack
