Feniks FUTURE Instruction Manual, No.
033-02-200
edition
IA
, 2012, page
12
of
36
AIR-POL Sp. z o.o.
– 05-120 Legionowo, ul. Olszankowa 52, www.air-pol.com.pl
tel.: (+4822) 774 0711, (+4822) 784 1595, (+4822) 774 4832, fax (+4822) 784 9640, @: [email protected]
Photo No. 11
3.
Place the deployment handle in the pouch
firmly, and secure it with Velcro tape.
4.
Place the line in the protective casing.
Photo No. 12
5.
Tie a granny knot to connect the RSL tape to
the line with the pin.
Photo No. 13
6.
If using the “Smart Loop” system, attach a
line with “Smart Loops” to the RSL tape. The
larger loop should remain free.
Photo No. 14
7.
Place the RSL tape in the container. The part
with the carabineer should be placed against
the riser ring. The part with the closing pin
(and the “Smart Loop” line) should be placed
against the reserve parachute container.
After you finish assembly, check whether the
tape is free of twists, firmly secured with
Velcro tape, and properly wrapped in the
casing.
Photo No. 15
8.
Fasten the RSL carabineer temporarily on the
riser ring on the inner side of the harness.
ATTENTION!
The entire system MUST be placed under
reserve parachute risers, allowing system
release from the container on the inner side of
the harness.
